FAAC 7110015-Plug Oil 400/402/422 for Rear Flange

Instructions

1. Disconnect power to the FAAC hydraulic operator before maintenance.

2. Locate the rear flange oil port on FAAC 400, 402, or 422 operator.

3. Remove the old or damaged oil plug.

4. Install the FAAC 7110015 oil plug securely in the rear flange.

5. Refill hydraulic oil if required according to FAAC specifications.

6. Ensure plug is tightened properly and check for leaks before restoring operation.

Safety

• Always disconnect power before performing maintenance.

• Use gloves and protective equipment when handling hydraulic oil.

• Do not overtighten the plug to prevent damage.

• Use only FAAC genuine replacement parts for safety and performance.

• Dispose of any used hydraulic oil according to local regulations.

Recommendations

• Inspect oil plug periodically for wear, corrosion, or leaks.

• Replace immediately if damaged to prevent hydraulic fluid loss.

• Maintain hydraulic oil at proper levels according to FAAC guidelines.

• Use original FAAC components to ensure reliable operation.